• ATD-1 Auto Tuner Disconnect Protection for lightning and RF surges.

Antenna Tuner disconnection systems for surge and lightning protection. Fed through coaxial cable with a Bias "Tee" or through separate cabling.

Protect Your Remote Auto-Tuner with the Array Solutions Auto-Tuner Disconnect

You’ve spent a lot of money on that remote auto-tuner.  When bad weather threatens, nothing protects your auto-tuner better than a hard ground right at the auto-tuner output.  But how do you do this unless you go outside and disconnect and ground the auto-tuner output when it is not in use?  The answer is the Array Solutions Vertical Antenna & Auto-Tuner Disconnect, which automatically grounds the antenna feedpoint and auto-tuner output when the DC control voltage to the unit is disconnected.  The DC control voltage may be supplied via the Array Solutions BIAS-T MASTER, or through a separate DC connection.  The DPDT relay used in the ATD-1 has 3.1 kV of gap and arc capability, which means that the ATD-1 can be used with full legal limit feeding antennas with an SWR of 60:1.  So there is no need to worry about ATD-1 arc-over into the worst loads presented to your remote auto-tuner.   The Array Solutions ATD-1 is perfect for protecting your CG, SCG, ICOM, and other remote auto-tuners.

 

ATD-1 Specifications:
  • Frequency coverage: DC-50 MHz 
  • Input : Single Wire 
  • Input power:  5 kW CW/SSB/RTTY
  • Power supply: Nominal DC + 12 V   (11.5-14 V DC)
  • Relay current: 125 mA
  • Plastic Box approx 4" x 4" X 2.5" (101 mm x 101 mm x 63.5 mm)
  • 20+ kV Rated

Can be used with a Bias Tee to avoid additional cabling by using the coaxial cable to send the 12 V DC to the ATD-1.

Two units needed, one for DC injection and one for DC extraction. 

ATD-1 used with bias Tees

Click here to see the Bias-T master

 

 

ATD-1 Auto Tuner Disconnect Protection for lightning and RF surges.

  • $199.00


Related Products

AT-615B - Automatic Remote Tuner for Balanced Feeders (Twin Lead, Open Wire, Ladder Line)

AT-615B - Automatic Remote Tuner for Balanced Feeders (Twin Lead, Open Wire, Ladder Line)

N-type connector input. Balanced Open Wire Line Terminal screws at output. Manually tune band segmen..

$2,950.00

DU800 - 800 W T-Network Tuner

DU800 - 800 W T-Network Tuner

Manual T-network antenna tuner. Circuit Morphology:    T- network Frequency Range:  ..

$539.00

DU1500L - 1.5 kW L-Network Tuner

DU1500L - 1.5 kW L-Network Tuner

DU 1500 L - L-Network Tuner.   Circuit Morphology:  L- networkFrequency Range / Pow..

$669.00

DU1500T - 1.5 kW T-Network Tuner

DU1500T - 1.5 kW T-Network Tuner

Manual 1500 W power rating T-network antenna tuner. Circuit Morphology: T- networkFrequency Ra..

$625.00

DU3000T - 3 kW T-Network Tuner

DU3000T - 3 kW T-Network Tuner

CALL FOR SHIPPING INFORMATIONManual T-network antenna tuner. Circuit Morphology:    T- ne..

$789.00

DU3000TB - 3 kW T-Network Tuner with 4:1 balun for balanced lines

DU3000TB - 3 kW T-Network Tuner with 4:1 balun for balanced lines

CALL FOR SHIPPING INFORMATION AND COSTManual T-network antenna tuner with 4:1 balun.   Circui..

$849.00

DU3500AL - 3.5 kW Automatic Tuner 

DU3500AL - 3.5 kW Automatic Tuner 

CALL FOR SHIPPING INFORMATIONAutomatic Antenna Tuner. Four SO-239 outputs and one Dummy Load Output...

$2,499.00

Tags: tuner protection, tuner disconnect, ATD-1, atd-1