Ring Rotator to install around the tower. Brackets to handle 12" (30 cm) face to 20" (52 cm) face towers (25G, 45G, 55G) 100 lbs (45 kg) max load. Wind load 1.5 m2 (16.1 sqft). One degree azimuth resolution.
All Stainless steel gears and bearings and hardware,
Boom plate is Aluminum, and motor is steel and cast Aluminum
Laser cut large gear ring, perfectly round and will not jump the motor gear, very little backlash
1 degree of repeatable accuracy
No potentiometers for position indication. Uses Hall Effect device.
Optically isolated. The best lightning protection possible
Self calibration, never loses calibration since it calibrates each time the sensors sees the position magnet.
Easy to calibrate, no need to assemble it calibrated or even know where North is.
Just put it up and calibrate from the shack
Can handle 5 element 20m beams, 3 element 40m full sized beams,
4 element shorty 40s, ~40 sq feet (initial spec) of balanced load
Worm gear braking
Brackets to handle 12" (30 cm) face to 20" (52 cm) face towers (25G, 45G, 55G) 100 lbs (45 kg) load max.
Can mount anywhere on the tower
1 degree to 500 degree programmable limits
Programmable soft start and soft stop over any angle and speed of ramp.
Split ring design allows easy installation
Approximately 75 lbs (34 kg)
Max wind area = 1.5 m2
Please call us for information concerning lead time.